OMRON | Mitsubishi
Home >> Download >> MITSUBISHI >> Motion Controller >> mitsubishi manual mitsubishi_manual_MR-J2S-CP Instruction Manual
mitsubishi manual mitsubishi_manual_MR-J2S-CP Instruction Manual
Introduction:

Any person who is involved in wiring and inspection should be fully competent to do the work.
Do not attempt to wire the servo amplifier and servo motor until they have been installed. Otherwise, you
may get an electric shock.
Operate the switches with dry hand to prevent an electric shock.
The cables should not be damaged, stressed, loaded, or pinched. Otherwise, you may get an electric shock.
During power-on or operation, do not open the front cover of the servo amplifier. You may get an electric
shock.
Do not operate the servo amplifier with the front cover removed. High-voltage terminals and charging area
are exposed and you may get an electric shock.
Except for wiring or periodic inspection, do not remove the front cover even of the servo amplifier if the
power is off. The servo amplifier is charged and you may get an electric shock.
. To prevent fire, note the following:
CAUTION
Install the servo amplifier, servo motor and regenerative resistor on incombustible material. Installing them
directly or close to combustibles will lead to a fire.
Always connect a magnetic contactor (MC) between the main circuit power supply and L1, L2, and L3 of
the servo amplifier, and configure the wiring to be able to shut down the power supply on the side of the
servo amplifier’s power supply. If a magnetic contactor (MC) is not connected, continuous flow of a large
current may cause a fire when the servo amplifier malfunctions.
MR-E-200A-KH003
MR-RB5H-4
MR-JCCBL2M-L
MR-PWCNS1
FX3G-14MT/DS
HA-LFS11K1M4B
FX3UC-32MT-LT
FX2N-16MT-001
FX2N-64MR-001
Q172HBCBL05M
QD75MH4
FX3U-48MT/DS
FX2NC-16MT
FX3U-64MT/DSS
FX1NC-32MT
HA-LFS11K1M
MR-J3JCBL03M-A2-L
FX1NC-16MT
FX3G-14MT/DSS
Q170ENCCBL30M
FX3G-24MT/DS
MR-RB50
AJ65MBTL1N-32D
FX1N-24MR-D
HC-MFS23B
A1SNMCA-8KP
MR-J3BCN1
HC-MFS053K
MR-ECNS
MR-J3BUS20M-A
MR-E10A
MR-J3ENCBL5M-A1-L
MR-J2S-55KA4
MR-J2S-200B4
MR-J3-20A
MR-ENCBL20M-H
FX2NC-ROM-CE1
MR-J2S-11KA4
FX3G-60MR/DS
A1SD75M2
MR-BKS1CBL5M-A2-H
MR-J2S-100B
MR-JHSCBL10M-L
HF-MP23B
FX3UC-96MT/D
MR-J2S-20A
Q2MEM-2MBF
MR-JCCBL10M-H
MR-J2S-22KA
FX1N-40MT-D
mitsubishi manual mitsubishi_manual_MR-J2S-CP Instruction Manual
Related Download