OMRON | Mitsubishi
Home >> Download >> MITSUBISHI >> Melsec-I/O Link Module >> mitsubishi SH(NA) mitsubishi_SH(NA)-Q Corresponding Intelligent
mitsubishi SH(NA) mitsubishi_SH(NA)-Q Corresponding Intelligent
Introduction:

Tighten the terminal screws with the specified torque.
If the terminal screws are loose, it could result in short circuits, fire, or erroneous operation.
Tightening the terminal screws too far may cause damages to the screws and/or the module,
resulting in fallout, short circuits, or malfunction.
• When disconnecting the communications cable or power cable that is connected to the module,
do not disconnect it by grasping the cable with your hand and pulling it.
Disconnect cables with connectors attached by taking hold of the connector at the connection
with the module and pulling the connector. For cables connected to a terminal block, remove the
cable after loosening the terminal block screws.
If the cable is pulled while it is connected to the module, it could cause malfunction or damage
the module or the cable.
• Be sure there are no foreign substances such as sawdust or wiring debris inside the module.
FX3U-16MT-DS
MR-J3BUS50M-B
A1SNMCA-8KP
MR-J2S-11KB
FX3U-48MT/ESS
FX3U-80MT/DS
FX3G-24MT/DSS
MR-J3-200B
FX2N-ROM-E1
AJ65MBTL1N-16T
Q2MEM-16MBA
GT05-MEM-1GC
MR-J3-100A
MR-J2S-15KA4
MR-J2S-22KA4
A1SD778M
HA-LFS11K1M4
Q172HBCBL5M-B
MR-BKS1CBL10M-A2-L
MR-J3-200A
MR-J2S-700B4
FX3G-24MT/DS
MR-J2S-60B
HC-MFS43B
MR-J3ENCBL5M-A1-L
GT1665M-STBA
Q173HB2CBL05M
HC-MFS73B
FX3G-14MR/DS
Q170ENCCBL5M
MR-J2S-15KB4
MR-J2S-37KB
FX2NC-EEPROM-4C
MR-J2HBUS1M
Q170BDCBL10M
MR-J2TBL05M
MR-J3JCBL03M-A2-L
Q173DVCBL1M
MR-PWS2CBL03M-A2-L
MR-E100A
A2SNMCA-30KP
FX3U-48MR/DS
MR-E70AG
MR-JHSCBL2M-L
MR-JCCBL2M-H
MR-J2S-500B
MR-J2CN1-A
MR-J3-500A
FX1N-40MR-ES/UL
FX2N-16CCL-M
mitsubishi SH(NA) mitsubishi_SH(NA)-Q Corresponding Intelligent
Related Download